[EuroX]

I've searched and found various posts saying this can be accessed by removing the grill...but in looking at the location of the reservoir it doesn't seem possible to remove through the front and I have no idea if I need to go through the wheel well or maybe from the bottom. Anyone have a DIY on removing the washer fluid reservoir on a 1st Gen X?

 

[XterraD4u]

If you remove the grill and take it loose I believe you can work it out of there by just rotating it slightly...idk, I will have to go look after it stops raining

Darin
01 Xterra SE 4x4
COMING SOON:
Intake mod, timing belt, hoses, belts
Wish list:
PML, EFan conversion, shocks, 32" tires, and eventually UCA'S

 

[EuroX]

If you remove the grill and take it loose I believe you can work it out of there by just rotating it slightly...idk, I will have to go look after it stops raining

Darin
01 Xterra SE 4x4
COMING SOON:
Intake mod, timing belt, hoses, belts
Wish list:
PML, EFan conversion, shocks, 32" tires, and eventually UCA'S

Alright, thanks in advance for checking if you have the time. I would have had a better look at it but wasn't even able to get the grill off because I can't figure out how to reach the little clips at the bottom of the grill. I have the top four clips off...but it appears there are one each under the headlights and maybe two others though I can't seem to get to them with a long flathead. Is there some trick to getting the grill off?

 

[XterraD4u]

So when I got out to look, I think it could be shimmy'd out the bottom if you just remove the lower valance...idk, I didn't try to loosen it to see since it is full

Darin
01 Xterra SE 4x4
COMING SOON:
Intake mod, timing belt, hoses, belts
Wish list:
PML, EFan conversion, shocks, 32" tires, and eventually UCA'S

 

[snunicycler]

Alright, thanks in advance for checking if you have the time. I would have had a better look at it but wasn't even able to get the grill off because I can't figure out how to reach the little clips at the bottom of the grill. I have the top four clips off...but it appears there are one each under the headlights and maybe two others though I can't seem to get to them with a long flathead. Is there some trick to getting the grill off?

I thought a long screwdriver was all you should need. I have an aftermarket bumper and the clips are all really easy to reach but there isn't anything other than the clips. I believe there are 3, one on each side and one in the center.

Sent from my VS986 using Tapatalk