Nissan XTerra Forum banner
manifold
1-11 of 11 Results
  1. Repair Questions
    I have been chasing down the cause of a P0300 (multi Cylinder Misfire) code for almost a week and a half. I have replaced numerous parts: Plugs and coils Both Crankshaft Position Sensors Intake Plentum Gaskets Both heated 02 sensors and one forward Checked fuel pressure (45-50 psi) Still...
  2. Repair Questions
    Purchased my new to me 2003 Nissan Xterra SE from an auction at a good price only to get the dreaded manifold problem. Getting ready to replace both exhaust manifolds. They have multiple cracks and makes plenty of noise. Got of them from Flebay. The studs look pretty good. Going to soak them...
  3. Repair Questions
    I am about to perform surgery on my 2004 X with 125k miles. I plan to remove the plenum and: 1. Change plug #6 2. Change the drivers side valve cover gasket 3. Replace the intake manifold gasket to stop a years-old coolant leak While I'm in there, what else should I change, replace or fix? I...
  4. Repair Questions
    I can not remove these things... It's like they are. I'm convinced that the metal nose and the hose have "become one". I'm sure some people on here know some tricks that might help. I can get my hand back there and pull down on it, but it's still not bulging. Help me before I decide to make this...
  5. Modification Questions
    ill preface this by saying i do not care about emissions systems nor is it ever checked in Ohio, now saying this, i bought my 03 X for 5gs out the door at a dealership and they cleared engine codes before selling it to me (Bastards) and i discovered i had an exhaust leak and a failure in the 1st...
  6. It Won't Start!!!
    About 2 weeks ago my wife called and said the car wont start. I had it towed back and took a look at it. power steering pump was bad...replaced it. (pain in the butt) After I replaced it, started it up and bleed the system...everythings fine. Took it for a spin to test everything out and...
  7. How To's, DIY and Write ups
    If I'm getting a leak in my intake manifold do I just need to replace the manifold gasket.
  8. Repair Questions
    When I got my Xterra, I knew immediately that it had an exhaust leak. Judging by older posts, its sounds like the manifold is cracked. Upon further reading, I see a DIY thread as well as solving the problem by welding the crack shut. With my X, I got a full service report full of old receipts...
  9. Repair Questions
    i have a 2005 nissan xterra off road 2x4. its a v6. i changed the spark plugs but when i put everything back together there is a vacuum line on the back of the intake manifold i can't find a hose for. does anyone know where i went wrong?
  10. Classifieds
    I recently bought a 2002 X, and found out that I need to replace the cat converter, and the exhaust manifolds. I have been looking around online, and have found some different options, but I don't know exactly what kind to get. If anyone can help me with which one to get, or if you have what I...
  11. Repair Questions
    hey guys, I just took my X into the shop to get looked at, and they said that there was a code on my Catalytic converter, and I had an exhaust manifold leak. I am not very versed on all of these parts, but would like to be able to know more about them, and if I am getting a fair price for the...
1-11 of 11 Results
Top