Nissan XTerra Forum banner
Cancel

Search Results for ‘intake manifold spacer’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results

Search Tags

1st gen 2000 2000 xterra 2001 2002 2002 nissan xterra 2002 xterra 2003 2004 2004 xterra 2005 2wd 4wd 4x4 a/c alternator battery body lift brakes bumper catalytic converter clarence clutch coolant coolant leak differential diode dynamics distributor diy drbandkgb electrical engine exhaust first gen fog lights for sale fuse headlights help help! hitch idle knock sensor lift lift kit lift kit advice light lights maintenance manual misfire mod mods new cx member new member newbie nissan no start noise noob o2 sensor off road offroad oil overheating paint parts pml rack radiator radio rear repair replacement rims roof roof rack rough idle shocks shrockworks start starter steering stereo supercharged supercharger suspension suspension lift thermostat timing belt tire tires towing transmission vibration wheel wheels wiring wont start xterra
  1. Repair Questions
    I'm about to remove the Plenum to replace the intake manifold gasket and have a couple of questions: 1. Is this a dry gasket or does it require either black or red silicone? 2. Can someone explain the difference in these two different offerings? One shows a three piece set and the other only...
    gasket intake manifold gasket intake manifold spacer sealant silicone
  2. Performance Mods
    I saw a couple threads about this but they seemed dead so I was wanting to make an ims for my first gen x but wondered if it was worth it. Was going to make it out of 6061 like the ims for the second gen x http://extremetruckperformance.com/?page_id=6 I was also not sure how thick to make it so...
    ims intake manifold spacer
1-2 of 2 Results
Top