Nissan XTerra Forum banner
Cancel

Search Results for ‘evap canister’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results

Search Tags

1st gen 2000 2000 xterra 2001 2002 2002 nissan xterra 2002 xterra 2003 2004 2004 xterra 2005 2wd 4wd 4x4 a/c alternator battery body lift brakes bumper catalytic converter clarence clutch coolant coolant leak differential diode dynamics distributor diy drbandkgb electrical engine exhaust first gen fog lights for sale fuse headlights help help! hitch idle knock sensor lift lift kit lift kit advice light lights maintenance manual misfire mod mods new cx member new member newbie nissan no start noise noob o2 sensor off road offroad oil overheating paint parts pml rack radiator radio rear repair replacement rims roof roof rack rough idle shocks shrockworks start starter steering stereo supercharged supercharger suspension suspension lift thermostat timing belt tire tires towing transmission vibration wheel wheels wiring wont start xterra
  1. Repair Questions
    My 02 Xterra SE 3.3L N/A (130,000 miles w/up to date recommended maintenance per drivers manual) will not reach above 2500 RPM, it will also die at RPMs lower than 1000 and it will also cut off randomly at certain speeds. It shakes, it sputters, it stalls and yes, check engine light stays on...
    evap canister maf sensor stalling surging
  2. Modification Questions
    So I had to replace the evap canister/ vent control and am looking for a way to seal it up so it doesnt get clogged again. Is there any info out there on How I might go about this? Ive seen only jeep skid plates but I dont think thats the answer. -ABelle
    evap canister vent control
1-2 of 2 Results
Top