Nissan XTerra Forum banner

Bellhousing Bolt Pattern

9K views 5 replies 2 participants last post by  Deley662 
#1 ·
Does anyone have any information on the bellhousing pattern on the back of our 3.3 blocks? I know its shared with at least whatever cars/trucks also had the vg33/vg30, but I can't dredge up any information about specific dimensions. Ideally I'm looking for a dimensioned drawing of the bolt pattern relative to crank center.

I've spent quite a bit of time searching through forums, service manuals, images, etc, and can't seem to find anything. Anyone have any idea where this info might be hiding?
 
#3 ·
That section is about the transfer case, and that diagram is torque specs for the bolts on the tailhousing. There is a similar diagram to this in the Transmission section I believe, but what I am looking for is a dimensioned drawing of the bolt pattern on the interface between the engine and the transmission bellhousing, not torque specs for the bolts.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top