Anywhere besides Nissan for exhaust studs asap? - Nissan Xterra Forum
 
Thread Tools Display Modes
#1 Old 12-12-2012, 11:51 PM
azgreaser
Member
 
azgreaser's Avatar
 
Join Date: Feb 2008
Location: Phoenix AZ
Posts: 45
2001 Xterra
azgreaser is on a distinguished road
Anywhere besides Nissan for exhaust studs asap?

I have had a night mare this whole week. Replaced my 2nd RH exhaust manifold which was cracked in 2 places, only to find out my Helicoil had gone bad on the head. I was able to get a shop to make me hard threaded insert to replace the Helicoil out of a bolt that they ran in lathe and hollowed out, then tapped the inside. After a successful fix, following the tightening sequence and finally torquing to specs...the next stud over stripped the head, wtf? I have come to the obvious conclusion that I need new studs and asap. Called Nissan in Dallas and the told me 2 days, but when I showed up to pay (because they wont place an order over the phone) They told me 2-5 days, and they wouldn't sell me the part without a my VIN, really??? They could not guarantee a time and I need this by the SAT. I am looking for 3 longer/upper studs and nuts or any advice on where to look. I will pay for overnight. I need to get to Phoenix on Mon. at the latest. I have tried almost everybody in town with no luck and thought on whim I would reach out on here. I thought about calling some junk yards but I am just having such a hard time with this that I would rather not. The shop that did the hard threaded insert gave me a m10 flange bolt that was the same length and thread...but I noticed after taking the exhaust back off that because the bolt was threaded all the way to the tip, it was trying to almost drill itself further in the block so I'm not sure it would have torqued down either.

Maybe I can find more of those m10 bolts and have them turned on the lathe to remove the end threads?

All of this because I misdiagnosed the rough idle which I am now 90% sure is was the distributor.lol That is installed with new wires and the exhaust needed attended to anyway...but talk about bad timing!

email me if you have any good studs (long not short) or a line on where to get them asap. retiznarted@yahoo.com

http://www.cardomain.com/ride/2908847 2001 Xterra 3" lift with 33's and fiberglass fenders

Last edited by azgreaser; 12-13-2012 at 12:09 AM.
azgreaser is offline  
2001 Xterra
Reply

Quick Reply
Message:
Options

Register Now

In order to be able to post messages on the Nissan Xterra Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.




Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode


Forum Jump

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off