I raised my pig up and threw 33's on it, there is a little rubbing when I cut it sharp. Should I completly remove the plastic that the mud flap was screwed into? also since i have no front bumper can someone post pics or a how to install a shrocks front bumper? I have this metal piece that looks like the bumper mounted to and that is where its rubbing, I was going to cut off the part that is near the tires but I am afraid I will need it when the new bumper shows up.

i took the plastics off. it helps with rubbing. mine still rubbs like a mug but it helped. imo it looks better too

I trimmed back to the cab corners to take care of the rubbing. But the shrock bumper mounts to the frame horns

20cc, how did you cut back your fenders like that? I've knocked those plastics off countless times and was thinking about just leaving them off but yours looks pretty clean. Any advice would help.

mines trimmed back to the cab corners amd the cab corners were pushed back about 2" to give me extra room. Although i downsized back to 31"s and god it looks rediculous lol until i put my tractor tires back on. Shroks dont mount to the body panels though.

msher, all i did was take them off, and use some plyers to get those little white clamps out. i pressure washed the area at one of those pay and spray car washes to knock all the junk off of it, then just waxed it. i t is a flatter color than the rest of the body work, but i think its better that was so you dont see dings and scratches as easy. and why paint the one spot on your car that stays covered in dirt?

Midget, how'd you push the cab corners back? I have rubbing issues because I run a 3.75" BS and 32x11.5 tires. I cut as much quarter panel as I could but need more. Esp if i'm going to go to 33's after the BL.


Sent from my Autoguide iPhone app