I just picked up an 02 2wd. Just got a look at the torsion bars and the drivers side is about 1.5 to 2 inches higher than the left. Is this going to ok when I go to adjust them? Should I still put them all the way down first then adjust them al the way back up to rasie the front end?

ummm i'd say no..when i cranked my bars i left the front up just a tad higher cuz thats the side i get in and out of all the time so i compensated for a little height loss..but its your call. good luck.

are you talking about the truck itself or the adjuster bolt?

i think he is talking about the bolt cause i wouldnt have drive away from the dealer if the truck was 1.5 to 2" lower on one side.....