I fought with these forever before I figured out how to remove these. I've seen plenty of posts asking for help on these models but didn't find where anyone responded. Its really very simple. First to make it easier to access the area simly remove the 3 shown phillips head screws. you can leave the other bolt and simply rotate the panel so you can reach up in the shown area. Go ahead and unplug the fog light from the wiring harness. Then remove the single mounting bolt from underneath the housing. Its actually the only thing really holding the foglight assembly in. Once that bolt is removed then all thats left is the two studs at the top. These are held by the pressure from the three tabs surrounding them. Just put a philips head screwdriver on the end of the studs and force them out of tabs (toward the front of the vehicle). Once those have been released the simply remove the assembly out the front of the vehicle and finish the bulb change.
http://playgroundofpain.com/downloads/foglight1http://playgroundofpain.com/downloads/foglight2

that would be for the 03-04 right????? i have a 00 and mine are rectangle i think the 02 are the same way..... i might be wrong....

I just changed the post title, Mine is a 2002 and it has round ones. I cant remember if the 2001 had round or square. I think the 01's are round too. Thanks though.

for the 04 all you have to do is unplug it and twist and pull out just like the headlights. it took me 2 mins to replace my bulbs...

ok i know the 00-01 are rectangle the 02+ went to round

2 or 3 posts prior to this one, the topic had just been covered? regardless, good pictures added

the one posted prior to this one was for a completly different year range therefore was a competly different method.

Hey, I don't know how this works, (dumb first timer...) Let me ask this. I have an 02', whats the trick to replacing burnt out marker lights? Front, side on bumper, and the headlight cluster marker light?

i will look in the service manual and find out.... the cluster should either have area in the back of it to pull the bulb out .... if not the cluster will have a couple of bolts or screws holding it in and when you remove them it should pull out and give you access to the bulbs..... right now i cant find it but i will post asap.....

if you have an 02 its easy the back of the light where the wires go in just unscrews by hand just remember that they take h3 style bulbs not the 899 style like the sylvania book and auto zone says