I didn't see this separate section for street wheels when I posted this same question in the offroad wheels forum... so sorry for the repetition..

Wheel compatability on 2010 question..

I have a 2010 X 4x4 and want to buy a second set of stock wheels for snowtires. I've found some 2nd gen stock wheels that are definitely compatible up to 2009. I figure they would be compatible with my 2010 but am looking for anyone who has actual knowledge that they would fit. I'm not planning on installing TPMS sensors in the second set so that doesn't figure in here. Thanks.

John

I highly doubt it changed. But your best bet would be to get out a tape measure and measure everything before you buy them.

That makes sense. I'll have to pull a wheel and take some measurements.

I'll be comparing my measurments to the ones I'm planning on buying but I figure I'll post them here for everyone.
Bolt pattern is 6 x 4.5". stock wheels are steel 16 x 7 JJ. Back spacing is about 5.375" (5 3/8"). I estimate that makes offset about 1.875" (47.6 mm) but not sure about that. wondering...Does this compare to 2005 to 2009 measurements?

Yep....thats the same as all the other 2nd gen Xterras.

2010 is a second Gen. The only thing changed is the grill, off road lights, and the dashboard, and a few interior color choices. Mechanically, all 2005-2010 are the same. You should be good to go.

Thanks for all the feedback guys. This really helps.

John

Bought and installed the 2009 compatible factory wheels onto my 2010 and they fit just fine. Thanks.