I just bought the white guages for my 2001 Xterra. Unfortunately they came without instructions. Anyone have any info on how to install these guages? Or where I could look?
Any help would be greatly appreciated.
Thanks
Rob

Do a search on this site. Bought a set and they were trash. I had to cut them down and make holes for my screws to go through. I advice you to send them back. Mine also didn't work right. The needles would get stuck on some areas. (like 50 mph). It was horrible. Then my RPM gauge was reading the wrong RPMs. The X would be parked in the garage in the off position and the RPMS would read like 2000.

Send that sh!t!! Where did you buy them from?

i thought i posted on this but now i dont see it. well i have found a bunch of diffrent ones and only a couple of them match my x i guess due to the diffrent pannels but if it didnt come with instructions then send them back due to the implications, if you drill or cut they wont take them back so good luck and tell me how it goes and if they fit right then let me know where you got them and ill try them out.......

Unfortunately I bought them on Ebay. The guy won't take them back and has no instructions. They are definitely chinese shit. Looks like they fit right over the old guages. They have a bunch of wires and plugs, also red and black wires for power and ground I assume. I will probably try taking the dash apart and see how tough it looks. If it looks like its going to be a problem, I will probably put it back together and chalk it up as a lesson learned. The guages only cost me $27.00 with shipping, so no big loss.
Rob

List them back on Ebay. :D

that sounds like a good thing to do. just sell them and be done with it